Yunbao VPN

Usage and troubleshooting

Which Route Does Windows Select with a VPN?

Microsoft’s Find-NetRoute reports the best local IP and route for a specified remote address. Compare a specific destination instead of inspecting only the default route.

Content updated:

Checks

  1. Obtain the target IP from support or app diagnostics. Use the same address to avoid changes caused by DNS rotation.
  2. In PowerShell, run Find-NetRoute -RemoteIPAddress 192.0.2.10. Replace this documentation example with your actual target.
  3. If disconnecting is allowed, note InterfaceAlias, NextHop and local address before and after connecting. If remote access depends on the VPN, record only the current state.
  4. Record which destinations change interfaces. If the interface stays the same, check app proxy settings before considering route changes.

Interpret the result

The command shows Windows routing for the specified IP. Check the public exit of a browser request separately inside that browser.

References and further reading

Back to all guides

Related guides

Usage guides

Browser Proxy and System VPN: Check Traffic Scope

A browser proxy is usually controlled by browser settings or an extension. A system VPN requires checking the actual connection and routing. Do not assume a proxy extension covers every application or infer VPN coverage from one webpage.

Network and privacy

What Do IPv4/IPv6, DNS and WebRTC Tests Tell You?

Understand public IP, dual-stack routes, DNS resolvers and WebRTC candidates without treating every difference as a leak.

Ready to connect?

Get the app from the official website and follow the instructions for your device.

Download ↓